LATCH UP PARASITIC THYRISTOR BASIC AND TUTORIALS

WHAT IS A LATCH UP PARASITIC THYRISTOR?

A portion of the minority carriers injected into the drift region from the collector of an IGBT flows directly to the emitter terminal. The negative charge of electrons in the inversion layer attracts the majority of holes and generates the lateral component of hole current through the p-type body layer as shown in Fig. 7.10.



This lateral current flow develops a voltage drop across the spreading resistance of the p-base region, which forward-biases the base-emitter junction of the npnparasitic BJT. By designing a small spreading resistance, the voltage drop is lower than the built-in potential and therefore the parasitic thyristor between the p‡-collector region, nÿ-drift region, p-base region, and n‡-emitter does not latch up.

Larger values of on-state current density produce a larger voltage drop, which causes injection of electrons from the emitter region into the p-base region and hence turn-on of the npn-transistor.

When this occurs the pnp-transistor will turn on, and therefore the parasitic thyristor will latch up and the gate loses control over the collector current.

Under dynamic turn-off conditions the magnitude of the lateral hole current flow increases and latch-up can occur at lower on-state currents compared to the static condition. The parasitic thyristor latches up when the sum of the current gains of the npn- and pnp-transistors exceeds one.

When the gate voltage is removed from IGBT with a clamped inductive load, its MOSFET component turns off and reduces the MOSFET current to zero very rapidly. As a result the drainsource voltage rises rapidly and is supported by the junction between the nÿ-drift region and the p-base region.

The drift region has a lower doping and therefore the depletion layer extends more in the drift region. Hence, the current gain of the pnp-transistor portion, apnp, increases and a greater portion of the injected holes into the drift region will be collected at the junction of p-base and nÿ-drift regions.

Therefore, the magnitude of the lateral hole current increases, which increases the lateral voltage drop. As a result the parasitic thyristor will latch up even if the on-state current is less than the static latch-up
value.

Reducing the gain of the npn- or pnp-transistors can prevent the parasitic thyristor latch-up. A reduction in the gain of the pnp-transistor increases the IGBT on-state voltage drop. Therefore, in order to prevent the parasitic thyristor latch up it is better to reduce the gain of the npn-transistor component of IGBT.

Reduction of carrier lifetime, use of buffer layer, and use of deep p‡-diffusion improve the latch-up immunity of IGBT. However, inadequate extension of the p‡-region may fail to prevent the device from latch-up.

Also, care should be taken that the p‡-diffusion does not extend into the MOS channel because this causes an increase in the MOS threshold voltage.

No comments:

Post a Comment

Related Posts Plugin for WordPress, Blogger...

ARTICLES